Dimensional Tolerances

Control of Distortion
Depending on the design of the part and its mold, some distortion may occur during cooling and solidification. The following tables show tolerances which may be expected with respect to given planes and shapes.

(Click image to Enlarge)

Parting Plane - Fig. A

"A" Dimensions: Any dimension contained completely within one mold half or within a core.

"B" Dimensions: To compensate for a compression of plaster mold halves at the parting line, or for hand positioning of cores.

"C" Dimensions: To compensate for possible mismatch or shift when mold halves are assembled.

NOTE: Where "B" and "C" tolerances affect critical dimensions adversely, they often can be eliminated by relocation of the parting plane.

Angles Normal:   ±1/2°
Radii Normal:    .030"
Surface Finish:  125 RMS or better

Length/Size - Normal Tolerance

0" to 1"  -  ± .010 1" to 6"  -  ±.015 6" to 11"  -  ±.020 Over 11"  -  Add ± .001/inch

Add ±.005 across one assembly point
Add ±.010 across two assembly points
Add ±.015 across three assembly points
Add ± 0.15 to “A" length tolerances

NOTE: Specifications, mechanical properties and tolerances given are nominal, and to be used as design considerations with Supreme's engineers as early in the design process as practical. The size and shape of an individual casting can effect tolerances, thus figures presented are not absolute.

*Design Data
Flatness and straightness limits are largely governed by the ability to mechanically straighten a casting. The values listed are based on a typical rectangular piece on which flatness was checked with a straight edge and feeler gage.

(Click image to Enlarge)

Back to Top